I downloaded the new firmware file from the Flex site - I was confused as to why it is a stand-alone program and doesn't use the new "install via the FlexRadio Driver" method.
Anyway - it pops up a little cmd window and goes along, clicks my Flex 3K relay when it is done - all seems OK. But, when I try to run PSDE (1.19.3 svn 3524) it hangs a few seconds into initialization. My Flex driver is version 3.5.0.71.71, PAL version is same. I am running this under W7x64 - I am running the firmware install as administrator - all the right stuff as far as I can tell. I can use the Flex Driver to reload 2.0.0.4 and all works fine - that was a big relief! Anyone else seen this behavior? Any suggestions? Best regards, Michael Jones W0STB _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using alpha and beta versions of the software.
