Alan,
First, set your squelches to zero. (I say that because sometimes you can
turn them off and sometimes not). Go into the audio equalizer (I use the
ten band) set the 250 hz to 3000 hz to max. and make sure the equalizer is
checked "on".
Then, don't try to use the master volume slider to enable you to hear it!
In fact, to eliminate the hum try to keep it below 30%. Use your audio
amplifier (I just happen to use a "retired" SONY ES for the purpose) to
bring the audio up. It won't sound good but it will be as good as any
litle asian box on 2M.
73
Lee
----- Original Message -----
From: "Alan NV8A" <[email protected]>
To: <[email protected]>
Sent: Monday, June 06, 2011 3:41 PM
Subject: [FlexEdge] 2.1 RC3: FM Rx audio way down
Flex 5000A + VU5K.
I just tried listening to our local 2M repeater with the 2.1RC3 software
and found that even with the audio cranked all the way up the volume level
was still too low. With RC1 the volume level is OK at a setting of 30.
Alan NV8A
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
