Dave, Here another hint. Plug your headphone or speaker directly into the phone connector of your MP3+ and press TUNE on the console. Now you should hear a tone with a frequency corresponding to your setting in the Setup/DSP/Keyer/CW pitch. The tone must vary in frequency when scrolling the setting of the cw pitch up and down. The QSD IC2 needs this tone to create a carrier and and low impedance speaker or head phone will attenuate the required signal from the soundcard. I am using the MP3+ since three years for cw and phone while waiting for the ultimate soundcard. To avoid said attenuation I use ahead of my speakers a stereo amplifier with high input impedance.
vy 73 de SM6OMH Willi ----- Original Message ----- From: "Eric Wachsmann" <[EMAIL PROTECTED]> To: "'Willi Reppel'" <[EMAIL PROTECTED]>; "'David Ackrill'" <[EMAIL PROTECTED]>; "'Philip M. Lanese'" <[EMAIL PROTECTED]> Cc: <flexradio@flex-radio.biz> Sent: Wednesday, September 20, 2006 11:44 PM Subject: RE: [Flexradio] Which way round? > Dave, > > This reminded me of something. You won't get good audio output if you > have > something plugged into both the Line Out and the headphone output on the > MP3+. This will load down the output and you'll get very little drive out > of the radio. Perhaps this was the issue? > > > Eric Wachsmann > FlexRadio Systems > >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] >> radio.biz] On Behalf Of Willi Reppel >> Sent: Wednesday, September 20, 2006 4:35 PM >> To: David Ackrill; Philip M. Lanese >> Cc: flexradio@flex-radio.biz >> Subject: Re: [Flexradio] Which way round? >> >> Dave >> Make sure that the volume control on your MP3+ is turned to position >> "max" >> to get output from the transmitter. >> vy 73 de SM6OMH Willi >> >> ----- Original Message ----- >> From: "David Ackrill" <[EMAIL PROTECTED]> >> To: "Philip M. Lanese" <[EMAIL PROTECTED]> >> Cc: <flexradio@flex-radio.biz> >> Sent: Wednesday, September 20, 2006 9:28 PM >> Subject: Re: [Flexradio] Which way round? >> >> >> > That's a relief then. >> > >> > The only time it really mattered, for me, was Red on the Right at the >> > Rear. Which indicated that the Red phase went to the right hand lug of >> > an 11kV triff box as you looked at it from the back of the >> > switchgear... >> > >> > That was before the IEE and the EU standards people got involved >> though... >> > >> > Anyway, so the MP3+ connections wont be the problem. >> > >> > I'm still at a loss as to know why my SDK1K would not transmit though. >> > >> > Dave (G0DJA) >> > >> > Philip M. Lanese wrote: >> >> David >> >> >> >> Since there are only two wires, I only have to dedicate two of the >> >> fast >> >> deteriorating synapses to remember 'R'ed 'R'ing. >> >> >> >> Phil, K3IB >> >> >> >> ----- Original Message ----- >> >> From: "David Ackrill" <[EMAIL PROTECTED]> >> >> To: <flexradio@flex-radio.biz> >> >> Sent: Wednesday, September 20, 2006 1:27 PM >> >> Subject: [Flexradio] Which way round? >> >> >> >> >> >> >> >>> Whilst my SDR1000 is away being repaired, I have been looking at the >> >>> connections between the Soundblaster MP3+ and the radio. >> >>> >> >>> Line in when to line in and line out to line out, so that's OK, but >> >>> checking the red and white connectors shows that the red is connected >> to >> >>> the ring (middle connection) and White to the tip on each lead. >> >>> >> >>> Is that the right way round? I'd have thought that the red went to >> the >> >>> tip, but I could be wrong. >> >>> >> >>> Anyone else using the MP3+ care to check for me please? >> >>> >> >>> Thanks - Dave (G0DJA) >> >>> >> >> >> >> >> >> >> >> >> > >> > _______________________________________________ >> > FlexRadio mailing list >> > FlexRadio@flex-radio.biz >> > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz >> > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ >> > FlexRadio Homepage: http://www.flex-radio.com >> > >> >> >> >> _______________________________________________ >> FlexRadio mailing list >> FlexRadio@flex-radio.biz >> http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz >> Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ >> FlexRadio Homepage: http://www.flex-radio.com > > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com
