>From what you described, the answer is yes. Polarization diversity is >possible with the F5K and the RX2.
RX1 can be assigned to RX1-IN, ANT1-3 RX2 can be assigned to RX2-IN, ANT1 (with the HRFIO-34 board) The for TX, you can assign it to ANT1-3 BTW, this is a very interesting idea and when it works (notice I didn't say "if"), I would love to get a write up about how you did it and the results for inclusion in the Knowledge Base. -Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of W7CE Sent: Friday, July 04, 2008 9:14 AM To: Flexradio Subject: [Flexradio] RX2 and dual transverters Can the 5000 with RX2 be configured to use dual transverters? Specifically, I'm investigating the use of dual synchronous 2M receive-only converters for EME, one for horizontal polarization and one for vertical polarization. These would then be used in conjuction with Linrad and K1JT's MAP65 software to allow automatic polarity combining and simultaneous decoding of all JT65B signals within the passband of the receiver. 73, Clay W7CE _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
