My N4PY software can do this for you.
Carl Moreschi N4PY
121 Little Bell Mountain Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Joe Camilli" <[email protected]>
To: <[email protected]>
Sent: Tuesday, July 28, 2009 12:47 PM
Subject: [Flexradio] LDG Z-100 Question
I have an antenna project that will require the tuner to be at the feed
point of the antenna. I currently have a LDG Z-100 to use. The Z-100 is
only
a semi-automatic tuner. The tune cycle is started by either pushing the
front button or by grounding the ring of the remote jack on the rear. Is
there a way to get PSDR/flex-3000 to perform this task?
Thanks Joe N7QPP
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage:
http://www.flex-radio.com/
Message delivered to [email protected]
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to [email protected]
