What does Ctrl Shift F do?
Brett
----- Original Message -----
From: "Ed Stallman" <[email protected]>
To: <[email protected]>
Sent: Friday, December 04, 2009 5:27 PM
Subject: [Flexradio] no power out 6 m zero watts
This happened when I updated SVN PB-Pal , My power on the HF bands went to
150 watts . I did the Ctrl Shift F to calibrate the power, all calibrated
fine until it got to 6m . At that point PSDR would stop and shut down.
Reading the mail on the reflector, I read were all calibrating need's to
be done using the official release. Today I installed Drivers,Firmware and
PSDR from the Flex web page (front page) Doing the power calibrate, all HF
bands did fine, This time when it got to 6m, it did not shut down PSDR ...
It just sat there and did nothing, I could see a wave form in the filter
bandwidth and the Mox tab was highlighted . I Gave it may be 5 minutes
before clicking X and stop on PSDR
I tried this with 2 different OS, windows XP home and Windows 7 32 bit.
their was no change with either,
So were did my 100 watts go on 6m ?
Yes I was in 96k and 1024
Yes I used a dummy load on port one
yes it was a new data base
Radio Flex 5000a
Thanks for any help , Ed
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage:
http://www.flex-radio.com/
Message delivered to [email protected]
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to [email protected]
