> Yeah, I haven't yet found a good set of rudder pedals. �The > Thrustmaster ones I use are adequate, but have a *lot* of slop in the > center section. �Fine control is difficult to impossible. �And the > lever arms are just rubbing plastic on plastic, so they're very > "sticky". > > There's a CH Products pedal set that a lot of people like. �I got to > try them once, but didn't like them much either. �Too close together, > and the pedals are independantly sprung (not linked into a single > physical axis), which feels wrong. > > I've thought for a long time about building my own set, but will > probably never find the time. :(
Check out these: http://www.rcsimulations.com/copy2.htm They are made here in the UK and are apparently quite well regarded. Too expensive for me though! As we are OT, can anyone tell me how to get my Saitek Cyborg working with SuSE 7.3 Pro/Linux 2.4.x ?? All the sites I have looked at say that it isn't supported. FlightGear crashes whenever I start it with the stick plugged into the joystick port 80( Regards, Matt. Maplin Electronics Ltd. www.maplin.co.uk This message is intended only for the use of the person(s) ("The intended recipient(s)") to whom it is addressed. It may contain information which is privileged and confidential within the meaning of applicable law. If you are not the intended recipient please contact the sender as soon as possible. The views expressed in this communication may not necessarily be the views held by Maplin Electronics Ltd. _______________________________________________ Flightgear-devel mailing list [EMAIL PROTECTED] http://mail.flightgear.org/mailman/listinfo/flightgear-devel
