Just a brief question, I'm getting back into 3d modelling and would like to contribute geometry corrections for the C172P (I have a fairly extensive library of photos/drawings for the type).
I'm just getting into AC3D as it seems rather pleasant to use compared to my usual tool, Blender, which while excruciatingly powerful is also slower to work with. My question is, can I commit changes to the C172 without 'stepping on someones toes' ? (I promise to make changes as accurate as my measurements and knowledge will allow). Or if there someone I should contact who is leading design for the model?. Thanks. Notes: Geometries I am looking to correct are the struts to the last spar before the wing taper, the thickness of the strut as viewed from the side (+30%), the angle of the exhaust, the nose leg and wheel and possible addition of the P's port-wing dual landing lights. I do not intend to add extra vertices except in the case of the port-wing landing lights. _______________________________________________ Flightgear-devel mailing list [EMAIL PROTECTED] http://mail.flightgear.org/mailman/listinfo/flightgear-devel 2f585eeea02e2c79d7b1d8c4963bae2d
