Hi Louis,
Please attach your xsl or resulting fo file and then someone will be able to
investigate the problem.
Adrian.
[EMAIL PROTECTED] wrote:
I'm converting from 0.20.3 to 0.94 and one of my reports is spitting out
the following message:
10:55:03,871 WARN [RowPainter] Replacing GU in slot 0. Some content may
not be painted.
Normally, I would not be that concerned with a warning, but I also get
the "File is corrupted" dialog when I try to access the PDF. The PDF
does open, but most of my data is missing (probably the result of the
warning).
Anyone got any ideas? I did not write the xsl so it could be a bad sheet.
-Lou
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
LOG-NET, Inc.
The Logistics Network Management System
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
230 Half Mile Road
Third Floor
Red Bank, NJ 07701
PH: 732-758-6800
FAX: 732-747-7497
http://www.LOG-NET.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
CONFIDENTIAL & PRIVILEGED
Unless otherwise indicated or if obvious from the nature of the content,
the information contained herein is privileged and confidential
information/work product. The communication is intended for the use of
the individual or entity named above. If the reader of this
transmission is not the intended recipient, you are hereby notified
that any dissemination, distribution or copying of this communication is
strictly prohibited. If you have received this communication in error,
please notify the sender immediately by telephone (732-758-6800) or by
electronic mail ([EMAIL PROTECTED]), and destroy any copies,
electronic, paper or otherwise, which you may have of this
communication. Thank you.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
