Does anyone know how to or if it is possible to assign clearance
requirements as well as width settings in the layout directives in
schematic? I have a whole sheet of signals that need special clearances and
the only way I can see in establishing this is to manually set up a PCB
design rule for each net on the sheet. Tedium at its worst. Any ideas?
Lloyd Good
Engineering Systems Co-ordinator
GE Harris Energy Control Systems Canada Inc.
2728 Hopewell Place NE
Calgary, AB, Canada T1Y 7J7
* +1 (403) 214-4777
* +1 (403) 287-7946
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
