Another option is to use a through-hole "component". The schematic symbol has 2 pins,
one connected to each net. The footprint has two (through-hole) pads that are close
enough to short (as described earlier). Place the footprint stradling the boundary
between the planes, so each thru-hole will connect to one plane.
Dwight Harm
Trax Softworks, Inc.
-----Original Message-----
From: Dan Klepper [mailto:[EMAIL PROTECTED]]
Sent: Sunday, May 27, 2001 7:32 PM
Hi Geoff,
thanks for your answer, is just I was wandering what would be the strategy
for �joining� internal planes?
Regards,
Dan Klepper
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
