Tim Hutcheson wrote:
>
> Yes, thanks, I was aware of those. I would just define a simple 4-part but
> I need to figure out how to define it like the RESPACK1 part, show that it
> displays as a single resistor. The book doesn't go into much detail about
> how to do this. I have to define 4-part packs for source termination of a
> microprocessor bus. So the individual resistors have to be scattered in the
> schematic but associated by pin number and pack designator. Seemed like
> such a common requirement that I expected to fined something in the library.
> Maybe someone has suggestions? TIA
In the schematic editor, click on "Tools/New Component" as you would to
make a single-part component, and draw the first part (or copy and paste
from an existing component). Then click on "Tools/New Part", and make
the second part. Repeat as needed.
--
Peter Bennett
TRIUMF
4004 Wesbrook Mall, Vancouver, BC, Canada
GPS and NMEA info and programs:
http://vancouver-webpages.com/peter/index.html
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
