At 02:57 PM 6/6/01 -0500, Tim Hutcheson wrote:
>Yes, thanks, I was aware of those. I would just define a simple 4-part but
>I need to figure out how to define it like the RESPACK1 part, show that it
>displays as a single resistor. The book doesn't go into much detail about
>how to do this. I have to define 4-part packs for source termination of a
>microprocessor bus. So the individual resistors have to be scattered in the
>schematic but associated by pin number and pack designator. Seemed like
>such a common requirement that I expected to fined something in the library.
>Maybe someone has suggestions? TIA
Find the symbol RESPACK1. In the list of symbols in the Schematic Library,
right-click on RESPACK1 and select Copy.
In your custom library, right-click in the symbol list and select Paste.
Rename the part to what you like, such as RESPACK4.
Using the part buttons, move to part 8.
Execute Tools/Remove_Part four times.
Edit each of the four remaining parts to change pins 16, 15, 14, and 13 to
pins 8, 7, 6, 5.
Assign an appropriate footprint
Save the library. Done.
[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
