Hello all,
I think it is possible inside Protel by using Client Basic. It should be
possible to write a small macro which calculates the X/Y points.
I didn't check but i am almost sure that there will be a 'placetrack'
process or something. You could use arc's, but short pieces of tracks will
do the job also.
For more information you can check the Protel site or the online help in
Protel.
Protel Knowledge Base Item
'Where can I find Examples of Macros in Protel 99? ' Item ID: 1897
Protel Knowledge Base Item
'Where can I find a list of Client Basic functions, parameters, types and so
on?' Item ID: 2045
Aalt Lokhorst (e-mail [EMAIL PROTECTED])
address:
Schut Geometrische Meettechniek bv
Duinkerkenstraat 21
9723 BN Groningen, The Netherlands
tel. +31 50-5877877
fax. +31 50-5877899
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
