Hi, I run V2.8 and 99SE in parallel (and at the same time) without any problems. Gisbert Auge "Robert Ritchey" <[EMAIL PROTECTED]> on 28.06.2001 16:09:54 Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> cc: Subject: [PEDA] 16-bit and 99SE Compatability Hi List, I know this is probably a really old question but I am finally upgrading from my 16-bit stuff to 99SE. I wondered if anyone could tell me if they can co-exist on the same machine without glitches if I install the 99SE in a new directory? Also, are there any tricks to keeping both running OK? Thanks, -Bob -------------------------------------------------------------------- Robert Ritchey Quest Engineering & Development 1328 East Cottonwood Lane Phoenix, AZ 85048-4765 Tel: (480) 460-2652 FAX: (480) 460-2653 E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] WWW: www.users.qwest.net/~rrritchey/ -------------------------------------------------------------------- * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/subscrib.html * - or email - * mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
