Yes i have the ip forward in my configuration. -----Mensaje original----- De: Tom Samplonius [mailto:tom at uniserve.com] Enviado el: Lunes, 07 de Agosto de 2006 12:07 p.m. Para: Ram?n Alvarez Rayo CC: foundry-nsp at puck.nether.net Asunto: Re: [f-nsp] Problem with NAT Foundry Server Iron XL
Don't you have to have ip forwarding enabled for NAT? I'm pretty sure you do, but I don't see "ip forward" below, but it could have been dropped during your cut-and-paste. Tom On Mon, 7 Aug 2006, [iso-8859-1] Ram?n Alvarez Rayo wrote: > We recently received a Server Iron Switch (16 10/100 + 2 Geth), i configured > this switch to do NAT for our networks, but we are experimenting service > instablility when we use as gateway the Server iron, some times is very show > and then few moments later is very fast. We want to replace a Cisco 3845 > that is doing NAT translation with this equipment but we can?t move to > production this equipment. > > > > The Software version is 07.5.00T12, and the config related to nat is the > following, actually we have only nat in this equipment. I tried to setup > the timeout for nat session and we don?t get any changes. > > > > What could be cause this issue ? > > > > vlan 200 name RED_PUBLICA by port > > untagged ethe 16 > > router-interface ve 1 > > ! > > vlan 199 name RED_PRIVADA by port > > untagged ethe 15 > > router-interface ve 2 > > ! > > ip nat inside > > ip nat inside source list 10 pool NAT1 overload > > ip nat pool NAT1 200.62.80.3 200.62.80.4 prefix-len 29 > > ip default-gateway 200.62.80.1 > > ip dns domain-name alfanumeric.com.ni > > ip dns server-address 200.62.65.1 > > > > interface e 15 > > speed-duplex 100-full > > ! > > interface e 16 > > speed-duplex 100-full > > ! > > > > interface ve 1 > > ip address 200.62.80.2 255.255.255.248 > > ! > > interface ve 2 > > ip address 192.168.4.254 255.255.255.0 > > ! > > > > access-list 10 permit 192.168.4.0 0.0.0.255 > > ! > >
