Andrea wrote: > Hi all, > first of all let me say I'm completely new to BGP. > I have to set up a BGP instance on my BigIron rx to manage redundancy > on 2 L2-ethernet link connecting my networks to partner ones. > > On remote site there's a couple of Cisco, I'd like to connect both > link to my only BigIron, my question is: > is it possible configure two BigIron ethernet interfaces to act as two > router? I've thought about use two ve interfaces with different ip, if > I use > switch ports I'll get an ethernet loop on the ISP ethernet infrastructure. > > I've searched for some configuration example, but with no luck. Foundy > documentation is very complete but with poor practical example. > Can somebody tell me where could I find some examples? > > (In test scenario I have to announce networks 154.54.64.0/24 > 156.54.70.0/24 172.29.0.0/16 172.16.0.0/16 and listen 172.19.0.0/16 > 172.20.0.0/16 192.168.0.0/16) > > Any hint is welcome. > Thanks in advance > Andrew > _______________________________________________
interface ethernet 1/1 route-only ip address X.X.X.X/30 interface ethernet 1/2 route-only ip address Y.Y.Y.Y/30 ..etc /Eric _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
