Hi, Since that both Ciscos will learn and advertise the same networks, why don't you try to make both ports into a VLAN with single VE ? Your BIgIron will see two gateways to the remote site. For achieving redundancy, it is better to link each Cisco to different module.
Best regards, > From: Andrea <[EMAIL PROTECTED]> > To: [email protected] > Date: Wed, 24 Sep 2008 16:12:04 +0200 > Subject: [f-nsp] BigIron RX BGP issue > Hi all, > first of all let me say I'm completely new to BGP. > I have to set up a BGP instance on my BigIron rx to manage redundancy > on 2 L2-ethernet link connecting my networks to partner ones. > > On remote site there's a couple of Cisco, I'd like to connect both > link to my only BigIron, my question is: > is it possible configure two BigIron ethernet interfaces to act as two > router? I've thought about use two ve interfaces with different ip, if > I use > switch ports I'll get an ethernet loop on the ISP ethernet infrastructure. > > I've searched for some configuration example, but with no luck. Foundy > documentation is very complete but with poor practical example. > Can somebody tell me where could I find some examples? > > (In test scenario I have to announce networks 154.54.64.0/24 > 156.54.70.0/24 172.29.0.0/16 172.16.0.0/16 and listen 172.19.0.0/16 > 172.20.0.0/16 192.168.0.0/16) > > Any hint is welcome. > Thanks in advance > Andrew _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
