Thanks Jeroen, I was unaware that this command existed. (route-only) Typing in 'no route-only' on the MLX fixed the issue.
Thanks again, = K On Tue, Sep 1, 2009 at 11:59 AM, Jeroen <[email protected]> wrote: > System Support wrote: > >> I am experimenting with a Foundry NI-MLX-4. >> >> I have a fast-E trunk to a Cisco router on eth 3/3 and another fast-E >> trunk to a Cisco 3750 on eth 3/20 >> >> The router has IP address 10.0.1.1/24 <http://10.0.1.1/24> >> >> The MLX router has IP address 10.0.1.2/24 <http://10.0.1.2/24> >> >> The 3750 has IP address 10.0.1.3/24 <http://10.0.1.3/24> >> >> From the MLX-4 I can ping both Cisco devices, but from either Cisco I >> cannot ping the other. >> >> Spanning tree on the devices show the proper ports are forwarding, but no >> traffic is passing. >> >> Any ideas ? >> >> is your MLX set to "route-only" in the "global" part of the config ? > > if you have set this, then it'll only respond to packets sent to it's own > address (the ve ), and not switch/forward the packages to the other IPaddres > (not local), on the other end of the vlan, defined on another port. > > Kind regards, > > Jeroen > > = K >> >> >> -------------------- >> >> MLX Config: >> >> vlan 1024 name Spantree_Test >> tagged ethe 3/4 ethe 3/20 >> router-interface ve 1024 >> ! >> interface ve 1024 >> ip address 10.0.1.2/24 <http://10.0.1.2/24> >> ! >> >> ---------------------- >> >> MLX4-01#ping 10.0.1.1 >> Sending 1, 16-byte ICMP Echo to 10.0.1.1, timeout 5000 msec, TTL 64 >> Type Control-c to abort >> Reply from 10.0.1.1 : bytes=16 time=271ms TTL=255 >> Success rate is 100 percent (1/1), round-trip min/avg/max=0/0/0 ms. >> >> MLX4-01#ping 10.0.1.3 >> Sending 1, 16-byte ICMP Echo to 10.0.1.3, timeout 5000 msec, TTL 64 >> Type Control-c to abort >> Reply from 10.0.1.3 : bytes=16 time<1ms TTL=255 >> Success rate is 100 percent (1/1), round-trip min/avg/max=0/0/0 ms. >> >> ======================= >> >> 3750-01#ping 10.0.1.1 >> >> Type escape sequence to abort. >> Sending 5, 100-byte ICMP Echos to 10.0.1.1, timeout is 2 seconds: >> ..... >> Success rate is 0 percent (0/5) >> 3750-01# >> >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> foundry-nsp mailing list >> [email protected] >> http://puck.nether.net/mailman/listinfo/foundry-nsp >> > >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
