with: ========================== cam-partition profile multi-service-2 cam-partition logging 95% 30 system-max vlan 4090 system-max ip-cache 384000 system-max ip-route 384000 system-max virtual-interface 4090 system-max ip-filter-sys 8192 system-max ip-vrf-route 32768 =========================== work fine for me =========================== sh ip bgp summary BGP4 Summary Router ID: x.x.x.x Local AS Number: xxxxx Confederation Identifier: not configured Confederation Peers: Maximum Number of IP ECMP Paths Supported for Load Sharing: 4 Number of Neighbors Configured: 54, UP: 49 Number of Routes Installed: 627833, Uses 53993638 bytes Number of Routes Advertising to All Neighbors: 977433, Uses 43007052 bytes Number of Attribute Entries Installed: 215712, Uses 20276928 bytes =========================== sh mem =========================== NetIron MLX active MP slot 33: Total SDRAM : 2147483648 bytes Available Memory : 1613049856 bytes Available Memory (%): 75 percent Free Physical Pages : 381772 pages
Malloc statistics: total 523540602 OS malloc count: 34025745 OS malloc fail: 0 OS free count: 34014445 OS free fail: 0 diff: 34025745 =========================== sh ver HW: NetIron MLX 4K Router Backplane (Serial #: SA04075088, Part #: 35550-000B) NI-X-SF Switch Fabric Module 1 (Serial #: SA04071783, Part #: 35548-100B) FE 1: Type fe200, Version 2 NI-X-SF Switch Fabric Module 2 (Serial #: SA02070657, Part #: 35548-100A) FE 1: Type fe200, Version 2 ========================================================================== SL M1: NI-MLX-MR Management Module Active (Serial #: SA01070600, Part #: 35524-101C): Boot : Version 3.5.0T165 Copyright (c) 1996-2007 Foundry Networks, Inc. Compiled on Jul 10 2007 at 19:13:56 labeled as xmprm03500 (424484 bytes) from boot flash Monitor : Version 3.5.0fT165 Copyright (c) 1996-2007 Foundry Networks, Inc. Compiled on Oct 31 2008 at 12:04:30 labeled as xmb03500f (422466 bytes) from code flash IronWare : Version 4.0.1aT163 Copyright (c) 1996-2007 Foundry Networks, Inc. Compiled on Jun 26 2009 at 20:06:08 labeled as xmr04001a (6682752 bytes) from Primary Board ID : 00 MBRIDGE Revision : 21 916 MHz Power PC processor (version 8003/0101) 166 MHz bus 512 KB Boot Flash (AM29LV040B), 32 MB Code Flash (MT28F128J3) 2048 MB DRAM ^^^^^^^^^ make fun Mitko On Wednesday 17 February 2010 08:02:06 George B. wrote: > You might also need to set some additional settings. > > The default maximum route cache is too small for a full ipv4 table. Try > increasing the following: > > system-max ip-route > system-max ip-cache > > The default for ip-route is 102400 with 4.0.1 which is what I am running. > So while BGP will handle more, they won't get installed in the routing > table unless you increase system-max ip-route. I currently have 314292 > routes installed and I believe I have the maximum currently set to 350000 > > George > > > > On Tue, Feb 16, 2010 at 2:40 PM, Niels Bakker > > <[email protected]>wrote: > > * [email protected] (Chuck Ufarley) [Tue 16 Feb 2010, 22:42 CET]: > > > > Is anyone running a full BGP table on an NI-MLX-MR blade with 2GB RAM > > > >> (which is max RAM, per the Foundry part list)? Any luck on that? Is it > >> possible? > > > > It's possible but you'll have to manually select a non-default CAM > > profile to allow for more routes in the hardware. Default is 262,144 > > which is not enough for today's Internet full routing table. > > > > See the "cam-partition" command in the manual, you'll want "ipv4" or > > "ipv4-ipv6-2" - no VPNs/VRFs then anymore, though. > > > > > > -- Niels. > > > > -- > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
