The RX series supports IPv6 relay agents for DHCP as well as IPv6 routing as of v2.702; the XMR/MLX series has the same as of v4.0.01. Also, most versions of the CER/CES series support DHCPv6(the CES 2000 series base package being the exception). Jonathan Brashear, BCNE Strategic Business Systems, Inc. 13241 Woodland Drive, 2nd Floor | Herndon, VA 20171 Work: 214-887-7719 x 101-7719 | Cell: 214.850.5986 Please visit our web site at www.sbsplanet.com
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of harbor235 Sent: Monday, August 23, 2010 1:18 PM To: [email protected] Subject: [f-nsp] dhcpv6 Does anyone know if any Brocade/foundry hardware supports DHCPV6? The applicable commands do not appear in the command line although they say they support it. Does anyone one else know of any Brocade/Foundry limitations as far as IPV6 goes? thanx harbor235 The information contained in this transmission may contain privileged and confidential information. It is intended only for the use of the person(s) named above. If you are not the intended recipient, you are hereby notified that any review, dissemination, distribution or duplication of this communication is strictly prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message. To reply to our email administrator directly, please send an email to [email protected]. _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
