On 15 May 2012 16:40, Dan Spataro <[email protected]> wrote: > Remco, > > You can use LSPs configured with strict primary and secondary paths for the > VPLS. This will allow you to control which way the VPLS traffic will flow > over your network. You can also configure your LSP to use fast reroute for > fast failover. Last time I checked you could not tell a VLL to use a defined > LSP like you can do with a VPLS. I think a work around is to map a COS to > the LSP and VLL.
There is also the *dirty* way of doing it - create a new loopback device, and do a new LSP between those two loopbacks, then set the VLL to that loopback. It will then take the alternative route. A manual way of steering of VLLs into certain LSPs would certainly be welcomed from Brocade, however. Matthew Walster _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
