Minimal, especially for an XMR: show ip route sum IP Routing Table - 2123 entries: 32 connected, 14 static, 0 RIP, 2077 OSPF, 0 BGP, 0 ISIS Number of prefixes: /0: 1 /16: 6 /21: 2 /22: 3 /23: 2 /24: 80 /25: 11 /26: 25 /27: 85 /28: 158 /29: 435 /30: 534 /31: 23 /32: 758 Nexthop Table Entry - 57 entries
sh run | include max system-max vlan 4095 system-max ip-route 400000 system-max virtual-interface 4095 default-max-frame-size 9000 > Subject: Re: [f-nsp] XMR LP running out of RAM > From: [email protected] > Date: Wed, 24 Jul 2013 10:59:53 +0200 > CC: [email protected] > To: [email protected] > > What is the output of 'show ip route summ' ? > > Kind regards, > > Job > > On Jul 24, 2013, at 10:14 AM, Darren O'Connor <[email protected]> wrote: > > > Hello all. > > > > One of our LPs (NI-XMR-1Gx20-SFP) keeps complaining in the logs: > > Current Total Free Memory (1601536) on LP 1 is below 5 percent of Installed > > Memory. > > > > This is an XMR4 that has two other 20 port copper line cards. They don't > > have the same issue. If I look at the memory usage: > > > > > > ==================================================================== > > NetIron XMR active MP slot 33: > > Total SDRAM : 2147483648 bytes > > Available Memory : 1705193472 bytes > > Available Memory (%): 79 percent > > Free Physical Pages : 406302 pages > > > > Malloc statistics: total 487040948 > > OS malloc count: 1261765297 > > OS malloc fail: 0 > > OS free count: 1261741808 > > OS free fail: 0 > > diff: 23489 > > ==================================================================== > > NetIron XMR LP SL 1: > > Total SDRAM : 1073741824 bytes > > Available Memory : 1601536 bytes > > Available Memory (%): 0 percent > > ==================================================================== > > NetIron XMR LP SL 2: > > Total SDRAM : 1073741824 bytes > > Available Memory : 548032512 bytes > > Available Memory (%): 51 percent > > ==================================================================== > > NetIron XMR LP SL 3: > > Total SDRAM : 1073741824 bytes > > Available Memory : 548032512 bytes > > Available Memory (%): 51 percent > > > > If I reboot LP1, the problem disappears for a bit then then comes back > > within the hour. Oddly there is nothing yet plugged into this LP. > > > > When I rconsole into the line card and do a show version. I see the > > following values at the bottom of the output: > > > > LP1: > > 559240 KB PRAM, 2048 KB AGE RAM and 1048576 CAM entries for PPCR 0 > > 0 K CAM2PRAM entries and 0 K TX VLAN entries for PPCR 0 > > Uptime : Day:5 Min:47 Sec:37 > > > > LP2: > > 16384 KB PRAM, 2048 KB AGE RAM and 1048576 CAM entries for PPCR 0 > > 2048 K CAM2PRAM entries and 4 K TX VLAN entries for PPCR 0 > > Uptime : Day:294 Hr:16 Min:24 Sec:28 > > > > Brocade support has been less than stellar when looking at this so I was > > wondering if anyone on this list has seen this issue before had any ideas? > > > > We are running 5.2C on this box. > > > > Thanks > > > > Darren > > > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > > -- > AS5580 - Atrato IP Networks > >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
