I had a similar problem with a VE in a VPLS. Try this: device(config)# no ip icmp redirects
http://www.brocade.com/content/html/en/configuration-guide/NI_05800a_SWITCHING/GUID-04EDFD31-E5FB-4593-8434-0DF8EDB3249E.html -Josh On Tue, Mar 1, 2016 at 3:12 AM, Franz Georg Koehler <[email protected]> wrote: > On Tue, Mar 01, 2016 at 09:59:02AM +0100, i3D.net - Martijn Schmidt wrote: > > The MLX platform is not a layer2 switch by default, so there are two > > ways to solve this problem: > > > > a) Use a VLL-local to bridge VLAN 999 from the firewall, through the > > MLX, to the ICX2. Then the MLX does not even learn the MAC addresses of > > the packets which are passing through. > > > > b) Perform a "no route-only" on all the interfaces which are involved in > > layer2 switching. > > There is already no route-only set on the interfaces in question (I forgot > to > mention that). The device is acting as switch & router. Otherwise, the > internal VLAN would not be switched with transparent-hw-flooding set as > well. > > I see that the switching does not work until transparent-hw-flooding is > set. I > wonder if this is related to the same mac address showing up in two > different > VLANs or some kind of loop detection. If transparent-hw-flooding is set, > the > device just floods all the traffic without analyzing it. > > > > Best regards, > > Franz Georg Köhler > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
