Thank you -----Original Message----- From: Jonas Frey (Probe Networks) [mailto:[email protected]] Sent: 23 March 2016 14:27 To: Nick Cutting Cc: [email protected] Subject: Re: [f-nsp] How to see the make and model of a transceiver
Hello Nick, you can do this via the hidden "dm" command: dm optic x/x/x eeprom This will show the eeprom contents of the transceiver (S/N, manufacturer etc). -Jonas Am Mittwoch, den 23.03.2016, 14:16 +0000 schrieb Nick Cutting: > This is on a brocade ICX6610 > > > > Is there a brocade equivalent of the cisco command show interface x/y > capabilities ? > > > > The show interface command gives me the below: > > > > SSH@ETGUKHEXSAN02#sh interfaces e 1/3/1 > > 10GigabitEthernet1/3/1 is up, line protocol is up > > Port up for 18 days 19 hours 23 minutes 23 seconds > > Hardware is 10GigabitEthernet, address is cc4e.24c2.efa0 (bia > cc4e.24c2.efc3) > > Interface type is 10Gig SFP+ Copper > > Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, > actual fdx > > > > So I know it’s a twinax cable (SFP+ copper – and I plugged it in)– but > I was hoping to get more information ? > > > Any ideas? > > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
