Show media should work on most everything. Mike
On Wed, Mar 23, 2016 at 8:25 AM, Nick Cutting <[email protected]> wrote: > Thank you > > -----Original Message----- > From: Jonas Frey (Probe Networks) [mailto:[email protected]] > Sent: 23 March 2016 14:27 > To: Nick Cutting > Cc: [email protected] > Subject: Re: [f-nsp] How to see the make and model of a transceiver > > Hello Nick, > > you can do this via the hidden "dm" command: > > dm optic x/x/x eeprom > > This will show the eeprom contents of the transceiver (S/N, manufacturer > etc). > > -Jonas > > > Am Mittwoch, den 23.03.2016, 14:16 +0000 schrieb Nick Cutting: > > This is on a brocade ICX6610 > > > > > > > > Is there a brocade equivalent of the cisco command show interface x/y > > capabilities ? > > > > > > > > The show interface command gives me the below: > > > > > > > > SSH@ETGUKHEXSAN02#sh interfaces e 1/3/1 > > > > 10GigabitEthernet1/3/1 is up, line protocol is up > > > > Port up for 18 days 19 hours 23 minutes 23 seconds > > > > Hardware is 10GigabitEthernet, address is cc4e.24c2.efa0 (bia > > cc4e.24c2.efc3) > > > > Interface type is 10Gig SFP+ Copper > > > > Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, > > actual fdx > > > > > > > > So I know it’s a twinax cable (SFP+ copper – and I plugged it in)– but > > I was hoping to get more information ? > > > > > > Any ideas? > > > > > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
