Hey Nick, that is the time since that arp was last seen, once the age hits
240 it would disappear. If it's active, it will refresh the age. I am
pretty sure it's in minutes, not seconds.

Mike
On May 24, 2016 11:21 AM, "Nick Cutting" <[email protected]> wrote:

On all of my brocade switches – my ARP timeouts seem to be about 10 seconds?



The documentation states that he default is 240 minutes (4 hours – same as
cisco)



I imagine the age is in seconds below?



Type     Age Port           Status

Dynamic  2   1/2/3          Valid

Dynamic  7   1/1/23         Valid

Dynamic  10  1/2/3          Valid

Dynamic  3   1/2/3          Valid

Dynamic  10  1/2/3          Valid

Dynamic  2   1/2/3          Valid

Host     3   1/2/3          Valid

Dynamic  2   1/2/3          Valid

Dynamic  10  1/2/3          Valid

Host     2   1/2/3          Valid

Dynamic  7   1/2/3          Valid

Dynamic  2   1/2/3          Valid

Dynamic  3   1/2/3          Valid

Dynamic  0   1/2/3          Valid

Dynamic  1   1/2/3          Valid





*Nick Cutting* | Network Engineer | Architecture & Standards Team| Office:
203-742-7856 | Fax: 203-742-7890



[image: cid:[email protected]]



_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp

Reply via email to