Thank you for the reply – I forgot to add that the entry also disappears.
It’s gone from the arp table after ten seconds – until I bring it back with a ping. e.g show arp 10.1.1.2 9 seen show arp 10.1.1.2 9 seen show arp 10.1.1.2 9 seen show arp 10.1.1.2 9 seen show arp 10.1.1.2 9 seen 4 more seconds… GONE Even if it’s not sending traffic – I would hope it stayed longer than that. There is not arp commands in the config – this is on the turbo irons and the FCX’s – am I missing something?? Thanks Nick From: Mike Allen [mailto:[email protected]] Sent: Tuesday, May 24, 2016 6:32 PM To: Nick Cutting Cc: foundry-nsp Subject: Re: [f-nsp] ARP Timeouts Hey Nick, that is the time since that arp was last seen, once the age hits 240 it would disappear. If it's active, it will refresh the age. I am pretty sure it's in minutes, not seconds. Mike On May 24, 2016 11:21 AM, "Nick Cutting" <[email protected]<mailto:[email protected]>> wrote: On all of my brocade switches – my ARP timeouts seem to be about 10 seconds? The documentation states that he default is 240 minutes (4 hours – same as cisco) I imagine the age is in seconds below? Type Age Port Status Dynamic 2 1/2/3 Valid Dynamic 7 1/1/23 Valid Dynamic 10 1/2/3 Valid Dynamic 3 1/2/3 Valid Dynamic 10 1/2/3 Valid Dynamic 2 1/2/3 Valid Host 3 1/2/3 Valid Dynamic 2 1/2/3 Valid Dynamic 10 1/2/3 Valid Host 2 1/2/3 Valid Dynamic 7 1/2/3 Valid Dynamic 2 1/2/3 Valid Dynamic 3 1/2/3 Valid Dynamic 0 1/2/3 Valid Dynamic 1 1/2/3 Valid Nick Cutting | Network Engineer | Architecture & Standards Team| Office: 203-742-7856<tel:203-742-7856> | Fax: 203-742-7890<tel:203-742-7890> [cid:[email protected]] _______________________________________________ foundry-nsp mailing list [email protected]<mailto:[email protected]> http://puck.nether.net/mailman/listinfo/foundry-nsp ________________________________
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
