I use Hypersnap for this. If you want to have the tear in the middle, you may have to cut the graphic in two, make the torn edge on the bottom of one and the top of the other, then put them back together.
-- Regards, Shmuel Wolfson Technical Writer 052-763-7133 Flato, Gillian wrote: > Does anyone know of a tool that allows you to erase part of a graphic > where when you run the brush through the graphic, the remaining visible > graphic looks like you ripped a piece of the graphic out of the middle? > So I want a tool that leaves a jagged edge behind. > > > > Thank you, > > > > > > Gillian Flato > > Technical Writer (Software) > > nanometrics > > 1550 Buckeye Dr. > > Milpitas, CA. 95035 > > *408.545.6316 > > 7 408.232.5911 > > * gflato at nanometrics.com <mailto:gflato at nanometrics.com> > > > > > colo1-dmz-mx1.nanometrics.com made the following annotations > --------------------------------------------------------------------- > Any views or opinions presented in this email are solely those of the author > and do not necessarily represent those of the company. Employees of > Nanometrics, Inc. are expressly required not to make defamatory statements > and not to infringe or authorize any infringement of copyright or any other > legal right by email communications. Any such communication is contrary to > company policy and outside the scope of the employment of the individual > concerned. The company will not accept any liability in respect of such > communication, and the employee responsible will be personally liable for any > damages or other liability arising. > --------------------------------------------------------------------- > > _______________________________________________ > > > You are currently subscribed to Framers as shmuelw1 at gmail.com. > > Send list messages to framers at lists.frameusers.com. > > To unsubscribe send a blank email to > framers-unsubscribe at lists.frameusers.com > or visit > http://lists.frameusers.com/mailman/options/framers/shmuelw1%40gmail.com > > Send administrative questions to listadmin at frameusers.com. Visit > http://www.frameusers.com/ for more resources and info. > >
