Robbie, Here are the specifications for VFN-1, as published by Kodak: http://motion.kodak.com/motion/uploadedFiles/US_plugins_acrobat_en_motion_support_processing_h2411_h2411.pdf
If you refer to pages 23-25, you'll find the formulas for the first developer and color developer, which are the critical components (on the processing side) that will determine the overall hue and saturation of the image. Also, please note that the module gives two alternative formulas appended with the abbreviation "LC" which stands for Low Contrast (so, probably want to avoid those formulas). The first developer is a very straightforward PQ developer with added thiocyanate; you shouldn't have any difficulties finding these ingredients, with the exception of the sequestering agent (Quadrafos). However, by using distilled water to mix the developer, you can avoid the use of this ingredient... The color developer, on the other hand, is a bit more complex to mix from scratch. However, since it's purpose is just to act as a redeveloper of the residual halides, it can be replaced with any other developer that retains the same color developing agent (i.e CD3). This includes ECN developer (not C-41) as well as the color developer in E6. The formula for ECN developer can be found here: http://motion.kodak.com/motion/uploadedFiles/US_plugins_acrobat_en_motion_support_processing_h247_h2407.pdf Bleach and fix are the same for all color processes -- Just use what's most readily available to you, or mix a simple ferricyanide bleach (15.0g Potassium Bromide / 15.0g Potassium Ferricyanide / Dilute to 1 Liter) and then use that in conjunction with any fix -- B/W or otherwise... As for altering the process to get higher contrast or color, you can try experimenting with the first developer. For instance, you could increase the ratio of hydroquinone to phenidone, or increase the alkalinity of the developer...you could also use there "LC" formulas to interpolate a possible equation for increasing the contrast.... Anyway, hope this helps, Kevin Rice processreversal.org pcn03031989.com (720) 270.3857 On Fri, Mar 13, 2015 at 3:20 PM, Scout Fenn <[email protected]> wrote: > Does anyone have a formula for processing the older color reversal 7240 > film , which was intended for VNF-1 process, but possible in E6. I'm aware > E6 process will provide result, but I'm hoping to achieve a higher contrast > more saturated image than what E6 results with this stock. Therefore, does > anyone perhaps have alterations to E6 or a VNF-like formula that may > produce higher contrast and color? Or perhaps a source? I'm hoping to > process as reversal rather than crossprocess. Thanks for any assistance . > -robbie > > _______________________________________________ > FrameWorks mailing list > [email protected] > https://mailman-mail5.webfaction.com/listinfo/frameworks > >
_______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
