In addition to the three screws on the back of the case, you need to remove the shutter release knob and the footage counter (top of the case). The latter has a spring washer under it, so don't lose it. The mechanism should slide/wiggle out as one unit, but if the case is bent or dented it could hang up on the edges. You can clean and lube easily without further disassembly; I think I basically soaked the entire mech in solvent.
On Tue, May 26, 2020, at 10:16 AM, Morgan Hoyle-Combs wrote: > > I was abe to loosen the bolts that held the camera mechanism in place, but > was unable to get the mechanism out. There was still something holding it on > there. I didn't want to take any chances by forcing it, so I put everything > back in place. If someone out there has the ability and tools to remove the > mechanism and oil down the gears while there at it, then thats all I would > like completed. > > M > > _______________________________________________ > FrameWorks mailing list > [email protected] > https://mailman-mail5.webfaction.com/listinfo/frameworks >
_______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
