I'm running current and get the following error in dmesg while trying to
enable the minipci.  This is a HP n5470 laptop.

dc0: <Accton EN2242 MiniPCI 10/100BaseTX> irq 11 at device 16.0 on pci0
dc0: failed to enable I/O ports!
device_probe_and_attach: dc0 attach returned 6

It is sharing irq 11 with the cardbus bridge.  As I understand this sharing
should work but I have my doubts.  To double check I have tried to change the
cardbus too use irq 10 by changing hints to irq 10 and by adding 


to loader.conf.  They don't make any chnge.  So I haven't been able to confirm
my suspisions.  Does anyone have a suggestion as to how I might be able to 
test this or fix it (would be even better:)?



pcic0: <TI PCI-1420 PCI-CardBus Bridge> mem 0x44000000-0x44000fff irq 11 at
device 4.0 
on pci0
pcic0: Memory mapped device, will work.
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][pci only]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-1420 PCI-CardBus Bridge> mem 0x44001000-0x44001fff irq 11 at
device 4.1 
on pci0

       The illiterate of the 21st century will not be
             those who cannot read and write, 
       but those who cannot learn, unlearn and relearn. 
                                                --Alvin Toffler

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to