I'm using the D-Link DGE 500SX Gigabit Ethernet card which gives the
following (error) message during bootup:

        lge0: Ethernet address: 00:50:ba:71:2d:c3
        lge0: MII without any PHY!
        device_probe_and_attach: lge0 attach returned 6

The correct Physical would be xmphy, which is correctly autoprobed under
-STABLE.  Do I have to configure something under CURRENT so that my
miibus physicals are detected?
        My imphy on the fxp (EEPRO100) is detected ok.

Regards, Robert S.

Robert Suetterlin ([EMAIL PROTECTED])
phone: (+49)89 / 30000-3546   fax: (+49)89 / 30000-3950

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to