I know this is the already the second place you have been directed to, but you may have more luck in freebsd-scsi. (cc'd there)
On Thu, Sep 04, 2003 at 02:42:30PM -1000, Richard Puga wrote: > I do have the ips driver working with the IBM ServerRaid 5i. However it > only works if I boot > of an IDE drive and load the driver after the kernel is loaded. > > What I believe the problem to be is the fact that this "Raid" card is > just an add in card to a > modified PCI slot that makes the on board LSI dual channel controller > into a RAID, and > something in the kernel is loading (not the LSI driver its been taken > out) which makes these > 2 separate devices act as one through the PCI bus and is the reason it > can only be loaded > after booting. > > I believe a quick and dirty fix for this may be to load the ips.ko > module after the kernel has booted > and before init mounts /. > > Is there a way to do this via something in /boot/loader (the standard > way in loader.conf loads it too soon) > or perhaps a way to compile isp into the kernel in a way that it would > be probed > at a later time or in a different sequence? > > Thanks again in advance > > Richard Puga > [EMAIL PROTECTED] > > > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "[EMAIL PROTECTED]" _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"