Hello,every one:
I have meet a problem when I am installing FreeBSD 4.1.1 on HP LPR.
HP LPR:
cpu: PIII 650MHZ *2
memory:384MB
Disk : 9G scsi-2 *2
Scsi card: HP NetRaid 1si
scsi card without raid (HP)
PhoenixBIOS 4.06.34 PR
Symbios,Inc.SDMS (TM) v4.0 PCI SCSI BIOS,PCI Rev. 2.0 ,2.1
Copyright 1995 ,1998 Symbios,Inc.
PCI-4.14.04
Symbios,Inc.Pci boot Rom ,no supported devices found.
HP NetRAID Adapter BIOS VER B.02.02 Apr 03,2000
Copyright(c) American MegaTrends,Inc.
the install process stop at this screen:
"..........................................
fxp0:<Inter pro 10/100B/100+ Ethernet> port 0x9400-0x943f mem 0xfa100000-0xfa1fffff,
0xfa200000-0xfa2fffff irq 11 at device 3.0 on pci1
fxp0: Ethernet address 00:d0:b7:91:20:d2
sym0: <895> port 0x9000-0x90ff mem 0xfa201000-0xfa201fff,0xfa202000-0xfa2020ff
irq 15 at device 4.0 on pci1"
after a long time ,it repeated messages on screen like :
".......
(noperiph: sym0:0:-1:-1): SCSI BUS mode change from SE to SE
sym0:0:iph:sym OUT phase after..........."
What problem? Who can help me?
The Lpr can be installed with windows 2000 Adv Server,run well but boot windows
needs a lot of time.
I can't install Redhat 7.0 on it ,too.
It stoped at load scsi driver.
Best Regards,
Flower
�R{.n�+���zwfj)m�f���h��ky�R���+a�{.n�+����盱�ZrG��)���w* ��z��
