At 01:54 PM 8/12/2008, Andrew Hotlab wrote:
I tried to boot without disks using the new firmware, but nothing
changed! Then I created a new RAID0
set/volume using only a single SATA drive (it was used as online
spare), but still not success... I'm afraid
to have ended any ideas about what it might be the cause of this trouble!! :(
I'll go on changing PCI-X slot of the Areca card, but I'm going to
became pessimistic about a successful
end of this story... sigh!
MB BIOS update ? On some more exotic boards I find I sometimes have
to disable some features, typically USB related, if there are
problems. Not sure in your case. I think MSI is enabled by default
on 7 and not on 6, so perhaps something on the board does not like
that ? Try disabling it in the loader.conf
hw.pci.enable_msi=0
---Mike
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
