On Tue, Aug 12, 2008 at 02:53:32PM -0400, Mike Tancsa wrote: > At 01:54 PM 8/12/2008, Andrew Hotlab wrote: >> I tried to boot without disks using the new firmware, but nothing >> changed! Then I created a new RAID0 >> set/volume using only a single SATA drive (it was used as online >> spare), but still not success... I'm afraid >> to have ended any ideas about what it might be the cause of this trouble!! :( >> >> I'll go on changing PCI-X slot of the Areca card, but I'm going to >> became pessimistic about a successful >> end of this story... sigh! > > > MB BIOS update ? On some more exotic boards I find I sometimes have to > disable some features, typically USB related, if there are problems. Not > sure in your case. I think MSI is enabled by default on 7 and not on 6, > so perhaps something on the board does not like that ? Try disabling it > in the loader.conf > > hw.pci.enable_msi=0
Don't forget MSI-X: hw.pci.enable_msix="0" -- | Jeremy Chadwick jdc at parodius.com | | Parodius Networking http://www.parodius.com/ | | UNIX Systems Administrator Mountain View, CA, USA | | Making life hard for others since 1977. PGP: 4BD6C0CB | _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[EMAIL PROTECTED]"
