Hello Pyun. I apologise for long delay, we had 3-day state holidays here. :)
On Fri, Aug 21, 2009 at 03:19:32PM -0700, Pyun YongHyeon wrote: > On Fri, Aug 21, 2009 at 05:20:39PM +0300, Eugene Perevyazko wrote: [...] > > > Then the driver recognizes the card: > > > > mskc0: <D-Link 560SX Gigabit Ethernet> port 0x4000-0x40ff mem > > 0xdc100000-0xdc103fff irq 16 at device 0.0 on pci1 > > msk0: <Marvell Technology Group Ltd. Yukon XL Id 0xb3 Rev 0x03> on mskc0 > > msk0: Ethernet address: 00:21:91:52:4f:09 > > miibus1: <MII bus> on msk0 > > e1000phy0: <Marvell 88E1112 Gigabit PHY> PHY 0 on miibus1 > > e1000phy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, > > 1000baseT-FDX, auto > > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ > This part is problem, you have finer media, so you should have just > 1000baseSX. [...] > > ATM there is no easy/clean way to pass driver specific data to mii > layer in FreeBSD so e1000phy(4) incorrectly thinks it found copper > PHY. Marvell PHYs seem to have no reliable way to know configured > media type of PHY hardware unless parent driver(msk) gives hint to > it. If you have just 1 NIC which uses e1000phy(4) on your system, > modify e1000phy(4) to force it having fiber media by inserting the > following line around line 114 in e1000phy.c. > > sc->mii_flags |= MIIF_HAVEFIBER; > I'm lucky enough that it's the only e1000phy NIC in the system, but I can't find the place you mean in e1000phy.c It's src/sys/dev/e1000/e1000_phy.c,v 1.1.2.2 and lines 112-115 are /** * e1000_null_lplu_state - No-op function, return 0 * @hw: pointer to the HW structure **/ I really doubt, there's any sense in patching this comment. Could you please give me a patch or precise instructions? -- Eugene Perevyazko _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
