My apologies if this is a repost. It seems either I had a gmail problem or list never posted the question. I have subscribed with another address to monitor problem.
Anyway, here is my quesion again. I get the following errors from dmesg on one of my ide drives on boot. Other similar drives dont error and are setup the same in bios (except cylinder & block config of course) System and this drive seem to work fine otherwise. I re-fdisk this one but it still does this error. FreeBSD 6.0-RELEASE-p6 #0: Tue Apr 4 09:43:53 MDT 2006 ad1: 1916MB <Maxtor 72004 AP 2A3C0B31> at ata0-slave WDMA2 ad1: FAILURE - READ_DMA status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND> LBA=3924359 ad1: FAILURE - READ_DMA status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND> LBA=3924343 ad1: FAILURE - READ_DMA status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND> LBA=3924356 ad1: FAILURE - READ_DMA status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND> LBA=3924359 I dont know what causes these errors either. dc0: failed to force tx and rx to idle state dc0: failed to force tx and rx to idle state Any ideas / suggsted reading somewhere on this? Thank You. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"