Hello All,

Last week, one half of my dual port Qlogic fibre channel interface
started causing a page fault panic while probing the second port at boot time.
I was able to get the system back up by disabling the BIOS on the
second port.  The system still sees the 2nd port, but politely
displays a few errors, then continues on.

This all started after I powered the system down for maintenance.
System is running FreeBSD 6.3-RELEASE i386

What is the proper way to help debug this problem?

Listed below is the current dmesg.boot info:

FreeBSD 6.3-RELEASE #6: Fri Feb 29 19:39:26 PST 2008
    [EMAIL PROTECTED]:/usr/obj/usr/src/sys/LAACO
module_register: module pci/bce already exists!
Module pci/bce failed to register: 17
module_register: module bce/miibus already exists!
Module bce/miibus failed to register: 17
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Xeon(R) CPU 5160 @ 3.00GHz (3000.12-MHz 686- class CPU)
  Origin = "GenuineIntel"  Id = 0x6f6  Stepping = 6
  AMD Features=0x20000000<LM>
  AMD Features2=0x1<LAHF>
  Cores per package: 2
real memory  = 3487916032 (3326 MB)
avail memory = 3409035264 (3251 MB)
ACPI APIC Table: <HP     ProLiant>
FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs
 cpu0 (BSP): APIC ID:  0
 cpu1 (AP): APIC ID:  1
 cpu2 (AP): APIC ID:  6
 cpu3 (AP): APIC ID:  7
ioapic0 <Version 2.0> irqs 0-23 on motherboard
isp0: <Qlogic ISP 2432 PCI FC-AL Adapter> port 0x5000-0x50ff mem 0xfdff0000-0xfd
ff3fff irq 19 at device 0.0 on pci19
isp0: Board Type 2422, Chip Revision 0x2, resident F/W Revision 4.0.70
isp1: <Qlogic ISP 2432 PCI FC-AL Adapter> port 0x5400-0x54ff mem 0xfdfe0000-0xfd
fe3fff irq 16 at device 0.1 on pci19
isp1: Polled Mailbox Command (0x8) Timeout (100000us)
isp1: Polled Mailbox Command (0x8) Timeout (100000us)
isp1: Mailbox Command 'ABOUT FIRMWARE' failed (TIMEOUT)
device_attach: isp1 attach returned 6

freebsd-questions@freebsd.org mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to