Go into the card 29320's BIOS and configure your tape drive for non-packetized
negotiation. If this works, we can try a few other things in the driver to see
if it is possible to get things working in packetized mode.
--
Justin
Jay Hall wrote:
I just installed an Adaptec 29320ALP-R in my FreeBSD 7.2 server.
Connected to the card is an HP Ultrium 1/8 G2 tape drive.
During the boot sequence, FreeBSD pauses to wait for the SCSI devices to
settle. Then, I receive the following message
(probe79:ahd0:0:4:0: Probable outgoing LQ CRC error. Retrying command.
I have moved the card to a different slot with the same results,
replaced the cable, etc. If I do not power on the tape drive, the
system will boot normally.
Any suggestions would be greatly appreciated.
Thanks,
Jay
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[email protected]"
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[email protected]"
