On Fri, Aug 14, 2009 at 08:23:49PM +0200, Fernando Apestegu?a typed:
> Hi all,
> 
> I'm trying to get my CD drive to work without so much success.
> Reading is fine, but when I try to burn a CD I get errors in dmesg.
> 
> Using cdrecord -blank=fast dev=3,0,0 I get:
> 
> [...]
> Using generic SCSI-3/mmc   CD-ROM driver (mmc_cd).
> Driver flags   : MMC-3 SWABAUDIO BURNFREE
> Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
> Starting to write CD/DVD at speed 18 in real BLANK mode for single session.
> Last chance to quit, starting real write    0 seconds. Operation starts.
> This drive or media does not support the 'BLANK media' command
> cdrecord: Cannot blank disk, aborting.
> cdrecord: Some drives do not support all blank types.
> cdrecord: Try again with cdrecord blank=all.

So what happened when you tried the blank=all option instead of your blank=fast?
You did try that, didn't you?

Ruben

_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"

Reply via email to