Hi, I'm trying to bring up the target-mode interface on a QLogic 2300 FC card. I have Matt Jacob's latest version of the driver, I have these lines in my config file for the kernel:
options ISP_TARGET_MODE device isp # Qlogic family device ispfw # Qlogic firmware The card does come up. The console messages include: isp0: <Qlogic ISP 2300 PCI FC-AL Adaptor> port 0xde00-0xdeff mem 0xfe9fd0000-0xfe9dfff irq 9 at device 6.0 on pci 1 (My apologies, but the quickest way to get this into the email is to copy it by hand, so I may have an error in there.) The opt_isp.h file is generated; it contains #define ISP_TARGET_MODE 1 At present, the FC card is unconnected. I do have a second SCSI card -- an Adaptec 29160 Ultra 160 -- which is ending up at 0xdd00-0xddff and 0xfe9fc000-0xfe9fcfff . It's running fine, so far as I can tell. With the SCSI devices, I have device scbus # ... [excuse me, I'm not typing the comments here] device ch # ... device da # ... device sa # ... device cd # ... device targ # ... device targbh # ... device pass # ... device ses # ... camcontrol devlist -v produces the following: scbus0 on ahc0 bus0: <BNCHMARK DLT1 5538> at scbus0 target 6 lun 0 (sa0, pass0) < > at scbus0 target -1 lun -1 () scbus1 on isp0 bus0: < > at scbus1 target -1 lun -1 (targbh0) scbus-1 on xpt0 bus 0: < > at scbus-1 target -1 lun -1 (xpt0) What I do not have is /dev/targ0, /dev/targ1, etc. They are simply not being created. This is 5.2, so they should just be there, no? I will be grateful for any help you can give me in finding out why, and getting them started. Mark Terribile [EMAIL PROTECTED] __________________________________ Do you Yahoo!? New Yahoo! Photos - easier uploading and sharing. http://photos.yahoo.com/ _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"