hello,
i have a 10/100 fast ethernet pccard labeled "sitecom".
it is built around the asix ax88790 chipset and runs at 10 mbit using the ed driver.
is 10 mbit/sec the maximum transfer rate the ed driver supports?
does somebody know a way i can use this card at 100 mbit/sec on my freebsd-5.3-release system?
the dmesg output for ed0:
ed0: <PCMCIA FastEthernet> at port 0x300-0x31f irq 5 function 0 config 7 on pccard1
ed0: [GIANT-LOCKED]
ed0: Ethernet address: 00:10:60:f5:e1:12
ed0: if_start running deferred for Giant
uname -a:
FreeBSD host1 5.3-RELEASE FreeBSD 5.3-RELEASE #2: Wed Dec 1 17:01:58 CET 2004 [EMAIL PROTECTED]:/usr/src/sys /i386/compile/NEU i386
ifconfig ed0:
ed0: flags=108843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 192.168.1.20 netmask 0xffffff00 broadcast 192.168.1.255
inet6 fe80::210:60ff:fef5:e112%ed0 prefixlen 64 scopeid 0x3 ether 00:10:60:f5:e1:12
thanks,
martin _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
