I have a dell 1950 here on the floor. Since "1950" seems to refer to a lot of things with a lot of configurations, I'm going to attempt to narrow that down a bit.
It's got 2x 2.33Ghz dual core pentiums (stepping 06-0F-6 according to the bios) in it and it has an SAS RAID card that FreeBSD recognises. I've upgraded the BIOS to 2.6.1. It has two SAS 70G drives in a RAID 1 configuration and it has a DVD (although it will only boot from CDs). If it helps, it's between 2 and 3 years old, I think. If I allow the machine to boot normally, it stopps after checking the floppy (there is no floppy) with the following message: fdc0: <floppy drive controller> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on acpi0 fdc0: does not respond device_attach: fdc0 attach returned 6 If I boot the machine without ACPI, it seems to stop at the same place (stopping after having checked the ata controller, which checks right before the floppy) If I boot the machine verbose, I get no more information --- it stopps at the same place. I have tried this (so far) with 7.2-R and 7.1-R. Both do the same thing. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[email protected]"
