On Thu, Nov 12, 2009 at 2:46 PM, Zaphod Beeblebrox <[email protected]>wrote:
> I have a dell 1950 here on the floor. Since "1950" seems to refer to a lot > of things with a lot of configurations, I'm going to attempt to narrow that > down a bit. > > It's got 2x 2.33Ghz dual core pentiums (stepping 06-0F-6 according to the > bios) in it and it has an SAS RAID card that FreeBSD recognises. I've > upgraded the BIOS to 2.6.1. It has two SAS 70G drives in a RAID 1 > configuration and it has a DVD (although it will only boot from CDs). > > If it helps, it's between 2 and 3 years old, I think. > > If I allow the machine to boot normally, it stopps after checking the > floppy > (there is no floppy) with the following message: > > fdc0: <floppy drive controller> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on acpi0 > fdc0: does not respond > device_attach: fdc0 attach returned 6 > > If I boot the machine without ACPI, it seems to stop at the same place > (stopping after having checked the ata controller, which checks right > before > the floppy) > > If I boot the machine verbose, I get no more information --- it stopps at > the same place. > > I have tried this (so far) with 7.2-R and 7.1-R. Both do the same thing. > > Can you disable the floppy drive and controller? There are usually separate options on different screens. -- Adam Vande More _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[email protected]"
