Mike Tancsa wrote:
[..]
Install the smartmontools from
/usr/ports/sysutils/smartmontools/
and post the output of
smartctl -a /dev/ad8
smartmontools was previously installed and running as daemon without any
bad reports.
I can not run "smartctl -a /dev/ad8" now, because my server housing
provider replaced HDD with the new one and after an hour of
synchronization "ad8: FAILURE - device detached". So provider replaced
whole server, only ad4 is original piece of HW.
On new server synchronization was much faster then in previous server
(1:30 hour compared to 5 hours in previous server) - so I think it was
HW problem.
Now I am running stresstest with copying /usr/ports to another partition
in infinite loop.
I will post results later. (On bad server, test failed after about 30
minutes. On another server the test is running fine second day, so I
think if disk will not fail after 1 day, problem is solved)
At last - now I think this was not GEOM/gmirror related. I tried remove
ad8 provider from gmirror (gm0), boot up system from gm0 with one
provider (ad4) and test ad8 mounted separately - ad8 failed again.
Miroslav Lachman
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
