The GEOM multipath code hasn't been MFC'd yet.
On Fri, 9 Mar 2007, Ivan Voras wrote:
Joao Barros wrote:
On 3/9/07, Ivan Voras <[EMAIL PROTECTED]> wrote:
I'm not familiar with this hardware, but I'm curious why I see the one
test drive I assigned to it twice. I seem to recall reading somewhere a
discussion for Linux in which it's been mentioned that one of these
should be a read-write and another "read-only" device, but is this
correct? I can write to both drives.
I'd say because you have a multipath setup, the driver being the exception.
I guess the in house isp guru Matt Jacob can give you a better
explanation ;)
I don't think it's because of multipath (as far as I understand it)
because both disks are atached to isp0:
da1 at isp0 bus 0 target 0 lun 0
da2 at isp0 bus 0 target 1 lun 0
There are two FC switches, but AFAIK a multipath setup would have, for
example one disk coming from isp0 and the other from isp1, as isp0 and
isp1 are connected to two switches...
It's entirely possible that something's ill defined in the FC management
console (I din't do it - it's another guy's responsibility :) )
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
