Hello,
I'm trying to sync a Palm Z22 under 8.0-BETA2 with pilot-xfer from
palm/pilot-link.
If I plug the Z22, the system doesn't create a /dev/cuaUx node. I had
the same problem under 7.X and 6.X, I used to patch uvisor.c (a very
dirty hack btw) to allow the creation of the device node.
So I applied the same changes to sys/dev/usb/serial/uvisor.c
Index: uvisor.c
===================================================================
--- uvisor.c (révision 195917)
+++ uvisor.c (copie de travail)
@@ -375,7 +375,7 @@
struct uvisor_connection_info coninfo;
struct uvisor_palm_connection_info pconinfo;
uint16_t actlen;
- uWord wAvail;
+/* uWord wAvail;*/
uint8_t buffer[256];
if (sc->sc_flag & UVISOR_FLAG_VISOR) {
@@ -496,7 +496,7 @@
goto done;
}
}
- DPRINTF("getting available bytes\n");
+/* DPRINTF("getting available bytes\n");
req.bmRequestType = UT_READ_VENDOR_ENDPOINT;
req.bRequest = UVISOR_REQUEST_BYTES_AVAILABLE;
USETW(req.wValue, 0);
@@ -508,7 +508,7 @@
}
DPRINTF("avail=%d\n", UGETW(wAvail));
- DPRINTF("done\n");
+ DPRINTF("done\n");*/
done:
return (err);
}
With this patch a /dev/cuaU0 node is created. If I launch a:
# pilot-xfer -p /dev/cuaU0 -i /home/marc/projet/misc/livres.pdb
Listening for incoming connection on /dev/cuaU0... connected!
Installing 'livres.pdb' ... (16 bytes)
ERROR: pi_file_install failed (-305, PalmOS 0x0000).
Thank you for using pilot-link.
So it fails where it worked on 7.X and 6.X.
Here are some info from usbconfig(8):
ugen2.2: <Palm Handheld Palm, Inc.> at usbus2, cfg=0 md=HOST spd=FULL (12Mbps)
pwr=ON
bLength = 0x0012
bDescriptorType = 0x0001
bcdUSB = 0x0110
bDeviceClass = 0x00ff
bDeviceSubClass = 0x0000
bDeviceProtocol = 0x0000
bMaxPacketSize0 = 0x0008
idVendor = 0x0830
idProduct = 0x0061
bcdDevice = 0x0100
iManufacturer = 0x0001 <Palm, Inc.>
iProduct = 0x0002 <Palm Handheld>
iSerialNumber = 0x0000 <no string>
bNumConfigurations = 0x0001
Any advices?
--
Marc
_______________________________________________
freebsd-usb@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-usb
To unsubscribe, send any mail to "freebsd-usb-unsubscr...@freebsd.org"
