On Sunday 23 January 2011 19:29:18 Matthias Apitz wrote: > El dÃa Sunday, January 23, 2011 a las 05:48:24PM +0100, Hans Petter Selasky escribió: > > On Sunday 23 January 2011 10:06:00 Hans Petter Selasky wrote: > > > Hi Mav, > > > > > > Do you know if there are any recent changes in the SCSI layer on > > > FreeBSD that will affect USB SCSI devices? > > > > Another idea: > > > > Maybe your device is too late identifying itself. You could try: > > > > usbconfig -d X.Y set_config 0 > > > > Then: > > > > usbconfig -d X.Y set_config 1 > > > > After that the device has been plugged. > > usbconfig -d X.Y set_config 1 always gives > usbconfig: could not set config index: Input/output error > regardless if the disk is plugged in or not; > > today once it connected by its own, i.e. it was sitting pluged in and > after a while it diconnected and connected again (without my action, I > was reading some mail): > > ... > Jan 23 18:10:03 tinyCurrent kernel: (probe0:umass-sim0:0:0:0): AutoSense > failed Jan 23 18:10:03 tinyCurrent kernel: ugen4.3: <Freecom> at usbus4 > (disconnected) Jan 23 18:10:03 tinyCurrent kernel: umass0: at uhub4, port > 1, addr 3 (disconnected) Jan 23 18:10:05 tinyCurrent root: Unknown USB > device: vendor 0x07ab product 0xfc8e bus uhub4 Jan 23 18:10:05 tinyCurrent > kernel: ugen4.3: <Freecom> at usbus4 > Jan 23 18:10:05 tinyCurrent kernel: umass0: <Bulk Only Interface> on usbus4 > Jan 23 18:10:05 tinyCurrent kernel: umass0: SCSI over Bulk-Only; quirks = > 0x0000 Jan 23 18:10:06 tinyCurrent kernel: umass0:0:0:-1: Attached to > scbus0 Jan 23 18:11:16 tinyCurrent kernel: (probe0:umass-sim0:0:0:0): > AutoSense failed Jan 23 18:11:16 tinyCurrent kernel: ugen4.3: <Freecom> at > usbus4 (disconnected) Jan 23 18:11:16 tinyCurrent kernel: umass0: at > uhub4, port 1, addr 3 (disconnected) > > and now it connects with success by its own: > > Jan 23 18:11:18 tinyCurrent kernel: ugen4.3: <Freecom> at usbus4 > Jan 23 18:11:18 tinyCurrent kernel: umass0: <Bulk Only Interface> on usbus4 > Jan 23 18:11:18 tinyCurrent kernel: umass0: SCSI over Bulk-Only; quirks = > 0x0000 Jan 23 18:11:18 tinyCurrent root: Unknown USB device: vendor 0x07ab > product 0xfc8e bus uhub4 Jan 23 18:11:19 tinyCurrent kernel: > umass0:0:0:-1: Attached to scbus0 Jan 23 18:11:19 tinyCurrent kernel: da0 > at umass-sim0 bus 0 scbus0 target 0 lun 0 Jan 23 18:11:19 tinyCurrent > kernel: da0: <Freecom Hard Drive XS 1.00> Fixed Direct Acc ess SCSI-2 > device Jan 23 18:11:19 tinyCurrent kernel: da0: 40.000MB/s transfers >
Try adding some mass storage quirks: kldload usb_quirk usbconfig -d X.Y add_dev_quirk_vplh x x x x x x --HPS _______________________________________________ freebsd-usb@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-usb To unsubscribe, send any mail to "freebsd-usb-unsubscr...@freebsd.org"